手机支架3D模型

RAM Phone Holder accessories

2024-01-11 01:50:11

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Okay, I have owned a bunch of RAM Mount stuff over the years, included probably half a dozen of these phone holders. I like these holders, but I always had a couple beefs with them. The first one was the little feet on the bottom. They always moved around and I used to hot glue them in place since I figured that was pretty easy to remove if needed.

Anyway, I finally got sick of this and made a clip? stopper? aligner? (I'll figure out a name later) The first one is a very simple piece that presses in to the groove on the bottom of the mount and holds the feet square and all the way to the outside. Print with TPU and just pop it in. Quick and easy. Print this standing up, with the skinny end down, and I normally use a raft.

The other thing that kinda bugged me with them is that I like to leave the mount just loose enough that the phone will just slip on and out. But with the newer skinny phones, many times it would just slip out the bottom, past the feet on the phone holder. Thus, this led me to making the 2nd and 3rd pieces that have little tabs that stick up, to help keep the phone from falling out. If you go this route, you don't need the first item.

Also print these in TPU, they slip over the bottom feet and then snap in to the bottom groove just like the first piece. There are two piece that need to be printed, one RT and one LT. I have found that it works best to flip the piece like in my picture, use a raft and tree supports. Like the first model above,these also keep the feet all the way to the outside, but add little tabs that stick up from the feet to hold the phone better.