跟踪式车辆系统

Track Vehicle System

2024-02-05 00:52:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Track Vehicle System

3D-printed track vehicle system with batteries and motor built into the tracks.

General info

The leading idea behind the project was to create a tracked vehicle system "in the comfort of one's home", with readily-available parts and a "not-expensive" printer.

Other milestone in the making of the project was to embed the motor and gearbox system, as well as the batteries, directly into the tracks.

Hardware

The motor is specified to run at 12600 RPM, and it's attached to a 100:1 gearbox system. Alongside of it, 6 pieces of 18650 cells in 3S2P arrangement are embedded into the track system.

For the minimal version, an ESP32 device was connected to a relay array which control the power switching, as well as the direction the motor is turning to.

Another ESP32 device is setup to send joystick commands to the first ESP32 chip via ESP-NOW communication protocol.

Various screws, threaded rods, and nuts and bolts were used, with some of the parts such as bearings or nuts also being printed.