卡尔模糊立方猫

Carl the Cube(ish) Cat

2024-02-05 08:20:03

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Be careful when breaking in the joints, or the joints might literally break. :-)

Carl is a cat that folds into a kind-of-cube-shape, better known as a rectangular prism. He is articulated and print in place.

Printing:

Carl's joints did not print correctly on my Anycubic, but printed fine on my Sovol. I recommend printing the test joint first to make sure your printer can handle it. The model is a little large at 100% (22 cm long) and might not fit on some smaller printer's build plates. I printed it at 70% (only 15 cm long) and it printed with some problems. The joints were slightly fused together, and some connections broke as they were weak. I also think I was using some filament that had absorbed some moisture, so, again, I recommend printing the test joint at whatever size you are trying.

After Printing:

The joints should (and will be) slightly stuck at first. Simply move then in the directions they are meant to move and they should begin working. The overhanging parts of his legs and tail may need to be trimmed for full functionality. If you don't want to have to do this, print with supports, thought hen you will have to trim the supports off, so take your pick. Enjoy Carl the Cat both in cat form and rectangle form. Please note that to move him from one form to the other will cause the segments to grind against each other a little. It is meant to do this so that when in one form or the other it stays in that form.

If you have questions or suggestions on how to improve this model, comment them on the model or message me and I will do my best to respond. Have fun printing!