3dsjs

索尼 WH-CH710n 左右杯架臂部件

Sony WH-CH710n L/R cup arms

2024-03-14 09:45:36

使用说明

  1. 所有模型资源均由用户上传分享,内容来源于网络公开资源
  2. 侵权投诉:通过抖音私信 @jobsfan 联系我们(需附版权证明),24小时内处理
  3. 模型将通过邮件发送(5分钟内自动发货),感谢理解带宽压力
关于费用

我们是爱好者共建社区,为维持服务器成本,每个模型收取微量费用(仅覆盖基础开支)。我们承诺最低成本运营,感谢您的支持!

扫码手机访问
抖音私信 @jobsfan

Summary

My WH-CH710n headphones decided to fail at the cup arms, snapping off. So I made new ones!

They're close to the original design however not perfect. At a distance however, nearly identical.

Post-Printing

Sanding would be ideal as after printing, the curves were rough on my prints. Maybe a sign that I need to spend more time tuning my printer.

Note that when mounting on the headphones, you will need to reuse the C-clip. This was designed in a way to avoid needing to desolder the wire and resolder.

INSTALL INSTRUCTIONS:

  1. Remove the old arm, will likely need to be broken off to avoid desoldering the wire.

  2. Once off, slide the wire through the hole at the top and push flush against the arm mount.

  3. Just like the old arm, put the C-clip back into place and done! It is now secured to the headband.

  4. To mount the cup onto the arm, place the wire into the guide

  5. Once done, slide the side with the wire into the hole first, and then push the other side down and let it snap into place. This will cause some discomfort and feel wrong.

  6. DONE!

(I will likely make a video thoroughly going through this at a later time.)

How I Designed This

A ruler, tears and 5 different prototypes.

Autocad Inventor was used to design this part.

License

CC BY-NC

Sony WH-CH710n L/R cup arms
by Txrtl3 is licensed under the Creative Commons - Attribution - Non-Commercial license.

索尼 WH-CH710n 左右杯架臂部件
朋友,你觉得上面这个模型,属于下面的哪个分类?
必须全中文,且长度不超过15

相关内容

猜你喜欢