XY尺寸校正测试

XY Size Compensation Test

2024-03-16 06:01:27

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Most FDM printers will make parts larger than they should be in the X and Y directions. This "XY expansion" can be undone in your slicer settings, but it is difficult to know exactly how much to offset this expansion. This is where the XY Size Compensation Test comes in handy!

The XY Size Compensation Test has five pieces that can slide in and out of slots. Each slot (and its corresponding piece) has an XY size offset between 0.1 and 0.5 mm After you print the model, you can decide which offset you like best, and use that offset in printing your future models.

The model dimensions are 75x20x8.5mm and it only uses about 10-15 grams of filament!

Note: Make sure that when you print this model, your XY size compensation is set to 0, and you have not scaled the model to a different size. I would recommend printing the "separated" model, with brim enabled. Also, after you know which offset you like best, it is easiest to change the XY size compensation in your slicer settings (not in cad). In the Prusa Slicer, you can find the "XY Size Compensation" setting under "Print Settings", and then "Advanced".

If you have any questions, suggestions, comments, or concerns, please leave a comment!