Subaru EJ25 后部主密封安装工具

Subaru EJ25 - Rear Main Seal Installation Tool

2024-03-21 02:32:59

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Provided here are two tools to aid in the installation of the rear main seal on Subaru EJ25 engine block. Both tools are designed to use the flexplate or flywheel bolts to evenly press the seal into place. PLEASE NOTE my car is a 5sp and as such I have a flywheel. The flexplate bolts might have a different length. The seal should be started by hand and then install the tool to press the seal in slowly (I recommend using 4 bolts in a cross pattern). I also recommend removing the tool at least once to check that the seal is moving smoothly and you are not rolling the lip over.

Version 1 (white): My first attempt. It leaves the seal flush with the ring on the block (which is too shallow in my opinion). It also includes sight windows for the user to check for problems as the seal gets pressed in. It is also a bit harder to print (I needed some support filament which I always hate). As shown it requires spacers as my flywheel bolts were longer than I thought.

Version 2 (red): Added a 1.5mm lip to push the seal in slightly further into the block. Deleted the sight windows to make it easier to print. Removed the need for washers/spacers.