RCWL-0516 3D模型标题

RCWL-0516

2024-03-23 01:55:01

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This case holds a RCWL-0516 microwave sensor and an ESP8266 Node MCU development board and allows the case to be held by the 5v AC adaptor that powers the MCU.
I don't screw the RCWL-0516 into the case, it fits snuggly and if you are worried that it will touch the back of the ESP8266, just put a little piece of cardboard between the two.
I haven't needed to do that is the tension of the wire keeps the boards away from one another.

It is simple and quick to print and modifiable for multiple projects.

Almost any small screws can hold to lid on, I normally just use something out of my junk box.

This is a version that hangs from a normal wall plug,

I bought some shorty micro usb cables from amazon to make it neater.

As bought the RCWL-0516 is very sensitive and in a 600 sq ft cabin it picks up when I roll over in my sleep, from the next room. I had to put a resistor on the sensor at the R-GN pads on the back of it. I think it was around 470k ohms.