双手操作抓握

Ambidextrous grip

2024-03-31 22:08:32

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I needed an ambidextrous grip because in the competitions I do there are exercises to be done even with the weak hand, I also wanted to optimize the two-handed grip.

This grip is perfect for my hands which are quite large.

You will need a serrated washer or a groover washer to improve the tightness of the screw which otherwise has a tendency to loosen due to the elasticity of the material.

Use a little sandpaper to fit the palm of your hand, especially where the two halves join.

I scaled the design to 104% to compensate for shrinkage in cooling, but maybe 103% would work too. I set up a Testfit to be able to do some tests without wasting time and filament.

Use the Brim with a good width (8/10 mm) and a little fixative on the plate, because the ASA with so much mass tends to warp.

Use a strong glue between the two halves to avoid problem during live fire.

NOT FOR COMMERCIAL USE!! - TESTED LIVE FIRE