紧急响应者门卡住装置

First responder door jam

2024-04-06 09:48:15

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is my design of a door jam similar to what first responders use to hold doors open. I intended to print in tpu but have yet to get that far with this project. There are two different models included that I have been testing with. I currently like the three hole version. Any recommendations would be greatly appreciated. I am still learning as this is my first printer.

This is intended for TPU, I have not tested with that material yet. With PLA the higher the infill the stronger it is but the less flex it has. I find that if you print this with PLA start at %50. If you find the door jam to be not flexible enough reduce infill by a small percentage. If you do to low when the door is slammed onto the door jam it will snap. If the infill is to dense it will not flex enough to fit a door without scratching it.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
No
Notes:
This is intended for TPU, I have not tested with that material yet. With PLA the higher the infill the stronger it is but the less flex it has. I find that if you print this with PLA start at %50. If you find the door jam to be not flexible enough reduce infill by a small percentage. If you do to low when the door is slammed onto the door jam it will snap. If the infill is to dense it will not flex enough to fit a door without scratching it.