参数化HDD/SDD适配器，通用设计，适用于HP ProDesk 600 G1系列机箱。

Parametric HDD/SDD adaptor, generic and for HP ProDesk 600 G1 cases

2024-04-08 11:28:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

参数化HDD/SDD适配器，通用设计，适用于HP ProDesk 600 G1系列机箱。

Summary

This project contains an OpenSCAD model of a 2.5" to 3.5" HDD adaptor.

The adaptor is designed to fit a 2.5" HDD into a 3.5" HDD slot. Sliders could be generated which will fit into a HP ProDesk 600 G1 computer case. Multiple adaptors could be stacked and screwed together to fit multiple 2.5" HDDs into a single 3.5" HDD slot.

The model is parametric and can be adjusted to fit other cases.

The latest version of this design could be found on:

Github: https://github.com/nomike/HDD-adaptor
Thingiverse: https://www.thingiverse.com/thing:6282650
Printables: https://www.printables.com/model/626664-parametrizable-hdd-adaptor-25-35-with-optional-sli

Usage

Just run make to generate files for all common HDD thicknesses and with all supported slider types.

Mounting

You should use M3 screws to mount the HDD to the adaptor. The screws should be 5mm long.

To connect two adaptors together you should use M2.5 cylinder-head screws and nuts. The length of those screws depends on the adapter height. The screwheads of the HDD mounting screw will pertrude from the underside of the adaptors. This has been accomodated by the design to allow enough space for stacking.

The top-most adapter could use the lowest profile version to save on filament and print time.

Instructions

Infill: 10%
Supports: no
Rafts: no
Material: PLA, PETG, ABS, etc.

Note: Even though I read somewhere that PLA is not suitable for HDD adaptors due to disks getting hot and PLA not being able to withstand the heat, I have been using PLA so far and haven't noticed any issues. I'm running a NAS where the disks are around 30°C in a room with ~20°C. And even on hot summer days the disks won't get near to any temperature where PLA would start to soften. PLA will begin to deform or warp at 60-65°C. Most HDDs are rated for 50°C, some for up to 60°C. So PLA should be fine for most use cases.