科斯·波塔·普罗耳机架（Pico Neo 3型）

Koss Porta Pro headphone holder for Pico Neo 3 headsets

2024-04-16 08:35:53

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a clearer (I hope) set of instructions for the articulated arm headphone holder, and it is combined with the Pico Neo 3 Link head strap clip.

I find that for small prints where accuracy is important it helps to print each part individually, so I have packaged the files that way.

The original articulated arm design clearly had multiple iterations and the instructions and files reflect that. So it took me a little while to figure it out. Hopefully my photos make it clear how it all goes together.

Thanks to the original designers. The arm design in particular is beautifully put together, I think. A lot of love clearly went into it.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
No
Supports:
No
Infill:
50%
Notes:
Layer height 0.12mm
Brim for the screws
No supports needed for any of the parts

Post-Printing

There are larger and small holes. At each connection you want the end of one part that has a larger hole aligned with the smaller hole at the end of the connecting part. That way the screws go through the larger hole first and then clamp that part to the other one by tightening into the smaller hole. Should be clear from my photos.

I could have fiddled with tolerances and settings but found it easier just to run a 6mm drill bit through the larger hole in the central connection (between the two main arms) after printing. Those need to allow reasonably free movement, so that the headphones can be flipped up.