派尼赛尔v2底座（站立式）

pinecil v2 stand (station)

2024-04-30 10:53:49

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A simple pinecil v2 stand/station without much bells and whistles. For added snap effect you can superglue a 10mmx0.75mm button magnet that will engage with the bottom screw on the pinecil.

print with a 0.2 to 0.3 mm layer height, 3 to 4 walls/perimeters, and no infill.
when it reaches 7 to 10 mm, pause the print and gently glue about 4 2-inch steel washers sandwiched together with superglue to the bottom interior of the base of the stand. the hot (60C) buildplate will help cure it quickly as you resume the print. the weight of the washers adds to stability by counteracting the weight of any thick USB/power cords you may be using.
no supports needed, the steepest overhang is 55 degrees; just make sure you use full part cooling
print in PLA Plus.

FreeCAD design is provided for convenience, but please note the no derivative and non commercial license. You can modify it to fit your needs but not to republish.