RC Crane V2

2024-05-05 21:10:28

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Enli10Me2 was a great start, but there were a few small things in my mind that would make it easier to build. I saw that his was based upon another build, so i took the good from that and combined.

First thing i did was enlarge the holes for the screws on the top parts where used. I found the 3m bolts i was using the heads kept stripping off, by doing this i was only putting pressure on where i needed the threads. I used the pulley, hook from ke5etc, also the pads and then modified the base beams to take a bigger screw.

Next I modified the Servo pully to fit on the servo gear, and the platform pully to accept a bearing on the top so it was free spinning.

I fixed the pins on the carriage as they were to big for the bearings.

I took the cab from the crane accessories and cut a slot in the side to run the RC cables.

Still have a few more things to do for cable management, and will post when i get them done.

This is still very much a work in progress, I will clean up the STL's and have some detailed pictures on the build and electronics when i get crane 2 completed

Print Settings

Printer brand:
Creality
Printer:
Ender-3 S1 Pro
Rafts:
Yes
Supports:
Yes
Resolution:
20
Infill:
20
Filament brand:
Overture
Filament color:
yellow / Red / Black
Filament material:
PLA, ABS
Notes:
I was using Creality Print and found that by raising the parts 2mm from the bed and then slicing, I had far less failures.