安全带夹扣

Seat belt clip

2024-05-01 03:19:47

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A clip that was built into into/around the seat belt broke on my camper van. In my case it was there to hold the buckle up against the back rest and make it not slide down into the bench and be hard to reach. I tried several existing designs on thingiverse but they all had too little friction to stay in place when the buckle was pulled on against the clip.

My design is fairly tight fitting around a single normal seat belt, it's 50mm inner gap to fit a 47mm wide seat belt. The design has openings you thread the belt into that lock when belt is applying tension. Note the locking will work well/poorly depending on if you make the belt go above or under the middle, it's not symmetrical.

Using mine printed in 100% infill PETG without supports.

安全带夹扣

朋友，你觉得上面这个模型，属于下面的哪个分类？