科洛克之魂：3D阿米博模型

Korok Amiibo

2023-06-04 19:26:52

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Korok Amiibo

By RyanT95 under Creative Commons - Attribution - Non-Commercial - No Derivatives license.

Design and Printing

I used Fusion360 to create a custom Amiibo base, referencing one of my own Amiibos. I tried to match it as closely as possible while taking some liberties to ensure good print quality.

The base is 50mm in diameter, slightly larger than the official Amiibo base, but not noticeably so unless measured. It works well with other Amiibos and looks almost identical to the official ones if prepared properly and painted nicely!

Printing

FDM/Parted:

Smooth out the flat surfaces of the two halves with sandpaper to improve glue adhesion.
Use superglue or similar to attach the two halves together.
Once dry, smooth out the seam edges until they're flush with the model surface.
Fill any gaps or seams on the model with your chosen filler material and sand it down smoothly for painting preparation.
Paint the model with a light-colored primer (white, gray, etc.)
You can paint the Korok with your choice of colors.

SLA/Whole:

Follow standard SLA post-processing procedures.
No gluing or sanding is required, as the print is in one piece and has no layer lines.
Paint the model with a light-colored primer (white, gray, etc.)
You can paint the Korok with your choice of colors.