福特温莎经典式超级充气器支架

Ford Windsor vintage supercharger mount

2024-03-13 13:59:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I made this mount for my dads 71 fastback mustang. I figured others might need this template to build a bracket for their car, the mount goes on the waterpump top 3 bolt holes, its for 70+ water pumps (earlier dont seem to have the mount holes I used). I think this would apply to all windsors after that point.
this uses the factory AC comp Tensioner. it may need some small adjustments but this will fit an SN60 paxton ball drive blower, possibly others and old mcculloch blowers.

Just a note, I only printed to confirm fit, I had these parts cut on sendcutsend in 0.25" mild steel, and 0.375" for the spacer on the blower.

you need 3x of the shims, one of the plate and one of the sn60 spacer.
they use 3/8-16 hardware (assuming you tap them, the holes are spec'd to be tapped in that size) 3 for the tensioner spacer, 1 for the tensioner itself.