1:144 比例星际飞船模型

Starship - Ship (1:144 scale)

2023-03-26 18:42:46

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

SpaceX'S Starship/Ship Upper/Second stage at a 1:144 scale. The flaps snap into places and rotate slightly in each direction, but can pop off if you rotate them without pushing inward. Fits on top of my SpaceX Starship/Booster model.

The booster is found here: https://www.thingiverse.com/thing:5673382

Filament Colors
Silk Silver - Starship body and flaps
Black - Heatshield
Gray - Engines

You will need to print 3 sea level engines, 3 vacuum engines, 2 forward flaps, 2 aft flaps, 2 forward flap heatshields, 2 aft flaps heatshields, and 1 of everything else. When printing the flaps (body and heatshield), make sure to mirror one of each. When attaching the heatshield to its corresponding flap, I recommend attaching it to the side that was in contact on the print bed so that the front facing, non-covered portion of the flap has the same finish as the rest of the rocket body.

Make sure to print the AftBottom upside down so you don't need need supports. But more importantly, the mounting holes need to be started from the build plate so that they actually come out circular. The heatshields can and were printed vertically (except the flaps).

I glued everything together with Gorilla Super Glue XL and it worked great. Be careful when wiping excess as it will smear on outside. I recommend inserting engines before gluing that section to the rest of the rocket body.

Nosecone Heatshield
The nosecone section of the heatshield may not sit completely flush with the rest of the heatshield below. There may be a tiny gap. I used black sharpie at the very edge on the rocket body and then applied the nosecone to make the gap a little less noticeable.

1:144 比例星际飞船模型

朋友，你觉得上面这个模型，属于下面的哪个分类？