激光切割刀具剪刀钝化工具 (Version 2)

laser cut knife and scissors sharpener (version 2)

2024-05-03 01:49:43

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Here is a knife and scissors sharpener.

It's version 2 of thing:6597331. This version enhances the guimbal. A linear bearing (LMUU10) is now holding the aluminium rod. No more play, motion is smooth and perfect.

https://youtu.be/SHpbb-il5og

It uses diamond stones,two of them being positionned on the handle.
Linear Ball bearings allow a fine utilization. Sharpening angles are easily determined.

This sharpener can be either 3D printed or laser cut into 5mm plywood.

If you laser cut, then use the dxf to cut all the part into one single plywood sheet (590x230 mm).
Then glue most of the part 2 by 2 to get a 1cm thickness, assemble the parts following pictures. 2mm toothpick could be inserted into the small holes to help you align the parts and add some strength to the assembly.
Insert the ball bearing (LMUU10 into the gimbal). Only this linear motion needs a bearing. Other rotation axis rotate directly into plywood. Don't oversize the holes...

If you print with 3D printer then use the stl files.

You can use "protactor Android App" to fine tune the sharpening angle between 13 to 30 degrees.

calibrate flat
then put the phone on the top plate and finish calibration
then put the phone on the sharpening stone and read directly the angle (see picture)

up to 9x1cm neodymium magnets can be glued into the holes on the top plate to help fixing the knife. Glue the magnets on a flat surface so that they are at the same level than the knife plate. Then glue the knife plate to the to assembly.

scissors can be fixed by an horizontal screw and sharpened with this device.
you can fix the device on your table using any clamp you want.

To finish assembly you will need

50cm aluminium tube (diameter 10mm) to fix the stones. The stone holder should slide almost freely on the handle side and a spring will insure a good fix.
On the other side the stone holder should be glued in place. If plywood you will have to drill the 8mm holes...
Two stones can be placed on the handle.
3x M5 hex nuts (2cm length) + 3x small washers
1x M8 lead screw (15cm length) + 6x nuts + 3x big washers)
1x M8 hex nut (2cm length + 1x small washer)
gimbal uses 2 6mm hex nuts cut to fit + 2 washers
vertical axis uses 1x 4cm M5 hex nut + 2 washers