威伯克格拉迪安NXT S形扩展模块

VKB Gladiator NXT S-shape extension

2024-03-23 09:00:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an extension for the VKB Gladiator NXT. It adds 120mm in length and 70mm offset to the rear. Using the medium springs you are going to get pretty much the same feel as with the soft springs without the extension. Please note that I cannot guarantee that this mod won't damage your gimbal although I've never had any problems.

You don't need any additional hardware as you can use the screws from the original side covers of the base. You could probably also use some M2,5 screws instead. The cable of course needs to be lengthened by about 16cm. You could alternatively also make a new cable which I did using some pre-crimped JST-GH cables.

Print Settings

Printer brand:
Creality
Printer:
CR10S PRO
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100%
Filament brand:
Polymaker
Filament color:
Green
Filament material:
PolyTerra PLA+
Notes:
I recommend printing it as shown in the picture tilted at 30° for good strength and printability. In this orientation, supports are only needed for the overhangs on the outside. The file is optimised to be printed like this on a stock CR-10S Pro V2. If you run into any problems concerning the fit of the grip in the extension or the extension in the base I recommend playing around with horizontal expansion.