雪佛兰 Volt 第二代货架支撑件

Chevy Volt shelf (gen2) support brackets

2024-03-28 19:10:20

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is for the Chevy Volt shelf (https://voltshelf.weebly.com/the-all-new-voltshelf-g22-and-more-for-2016-19-volts.html) that can be used in a SECOND gen Chevy Volt. This is an amazing item that I highly suggest for Volt owners as it covers the large trunk from full sun exposure and prying eyes, as well as isolates it for less wasted heat/AC in an area that doesn't need it.
I disliked the metal brackets that came with the Chevy volt shelf, they would often snag, and when opening the trunk flip out of position.

So instead I opted to modify the two rear cover/net holding locations to be large brackets for the shelf to sit on.

These assemble with m2.5x6mm screws (8mm long works as well and may be better) and print in two parts because otherwise the forces of the shelf dropping on the part would sheer the print after a couple uses. It is a snug fit and may need to be slightly pressed into the opening before you can twist it to lock it. I used a pair of needle nose pliers to twist the stock ones out of place without breaking them.

This part does NOT have the little nub in the center for holding a net or the soft cover in the trunk, HOWEVER it does have a hole so you could alternatively hang them upside down and use a wooden dowel though them if you prefer that to hold your shelf in place.

I have not tested these yet in full summer heat. I'd suggest you print with PETG or ABS for better weather durability, the interior of a car can get hot in the summer with full sun a PLA print can and WILL start to sag with use if it gets too hot. either pulling out or dropping the shelf down into the trunk.

I printed mine with decent infill but more importantly I used thick walls (1.2 to 1.6mm) so that it would be more robust, and the screws would have more material to grab onto to hold the whole thing together.