定制款剪刀盒（Leviathan Cross）

CUSTOM CLIPPER CASE (LEVIATHAN_CROSS)

2024-04-15 00:02:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A 3D printable lighter sleeve with a customized "leviathan cross alchemical symbol" embossed in the front.

Print with vase mode (or "spiralize outer contour" setting in cura) on and adjust the layer height to dial in the smoothness of the sleeve and the line width (I'm using respectively .1mm and .46mm with a .4mm nozzle), the wider you go the slower you should print (Here I go with 20mm/s but you have to figure out the speed with your filament and printer). Lastly adjust the number of bottom layers (I use 4 but you should experiment a bit).

Prints slightly better with a brim but it's NOT necessary.

NOTE: by adjusting the layer height and line width, you are altering the physical dimentions of the printed part. If the settings are producing a good finish but the lighter doesn't fit anymore, just upscale the model in your slicer .5% at a time.

pps: If you're getting artifacts that look like underextrusions in vase mode, try adjusting your z offset.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V2 Neo
Rafts:
No
Supports:
No
Infill:
0
Filament brand:
Creality
Filament material:
Hyper PLA
Notes:
Print with vase mode (or "spiralize outer contour" setting in cura) on and adjust the layer height to dial in the smoothness of the sleeve and the line width (I'm using respectively .1mm and .46mm with a .4mm nozzle), the wider you go the slower you should print (Here I go with 20mm/s but you have to figure out the speed with your filament and printer). Lastly adjust the number of bottom layers (I use 4 but you should experiment a bit).