Pi型箱体设计用于Neptune系统，配备摄像头模块V3。

Pi Case for Neptune with Camera Module V3

2023-08-08 00:27:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is raspberry case with adjustable camera mount (on a pole). The case was designed to attach to ELEGOO Neptune 3 Pro rails (might be okey for other models having rails on the sides). It does not require disassembly of the printer as it snaps snag using hangers.
The pole fits very snuggly, you can use file to smooth hole on the case to help adjust it.
Screws for the case are typical M3 16mm (3x).

The PinLock should fit snuggly as well, adjust printer settings if it is too tight or use file as well.

Print orientation (if support is mentioned use TREE support!)

Pole: print 0.2 upside down on the plate (DO NOT PRINT ON THE SIDE!). No suport, no brim. Use 4 or 5 walls to make pole stronger.
CamLid: print 0.2 stand straight, enable tree support for a top bar, no brim
CamCase: print 0.2 stand straight, enable tree support, no brim
PinLock: print 0.15 upside down (on the head), no support, no brim
Top of the case: print 0.2 flat side, use brim to prevent wrapping of the case, no support
Bottom of the case: print 0.2 flat side, use brim as well

Good luck and have fun.