v400龙纹装饰板

v400 dragon-berd plate

2024-01-16 13:13:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Page under-constuction Inital release further minor changes/requests could be possible.
Will be supported on aio configs in the short future.

Recommended material absolute minimum" petg it'll work
Ideal material pa6cf/12 , abs namely we want to avoid deformed plates due to power outages or similar scenarios that would require a new plate if the hotend isn't cooled before powering off.

6-8 walls
2mm tops / bottoms
35-45 percent infill gyroid or, cubic
line with 0.4 - 0.5
layer height 1.5mm -2.5mm or, adaptive layers

Possible configurations , bowden , flying or even direct with hevort or similar Jhead mounting extruders (anything SUPER light) otherwise im not sure what the benefit would be outside of using a high end hotend)

Supported couplers M6 bowden couplers Note you must find the though hole type, hotends like the rapido require the tube to pass though the coupler,
Most dragons come with a e3d/jhead adapter this will work as well and, would be used for a direct drive mount.

Currently required.
berd air pump / tube / tubes
ez board,

Kossel type membrane probe (nozzle direct type) TriangleLabs also carrys them.
Namely this avoids issues with tilt related tramming problems. or, probing reliable wrong as kevin puts it regarding the stock probe type... Due to square issues / semi bent probes or other related micro alignment issues.

Disclaimer on "pads without vanilla klipper aka "official" a highly doubt tramming will work due to it being disabled. The coding changes hinge on a factory perfect machine to work id expect any deviations from stock to become problematic or maybe not.

Fans currently only the berd-air pumps
Later a dual 4010 setup

Theoretical generic defaults
8000-10000k
scv 30-60+

Results will very etc. id start by just increasing scv and, finding a good general value this will be the max speed on outer walls "without' input shaper(compensation features) once a ideal printer specific range is found then apply input shaper / whatever slicer settings like higher speeds on internal things ghosting wouldn't matter on.. Tip high uniform speed values should work before needing to offset internal things.

v400龙纹装饰板

朋友，你觉得上面这个模型，属于下面的哪个分类？